Quantcast
Channel: Movano and Vivaro (including Renault/Nissan Derivatives) Commercial Vehicles owners forum
Viewing all 5961 articles
Browse latest View live
↧

Vivaro clutch pedal

May 1, 2016, 11:47 am
$
0
0
I have a strange problem with my Vivaro, its an 06 1.9. It is an intermittant problem where the clutch pedal can be going down ok and all of a sudden it becomes very hard to press, almost solid, but appears to disengage the clutch because the gears didnt grind. It started happening approx 9 months ago and then did not happen again until yesterday, but after leaving van for 3 hours it seems to have cleared itself and drives fine? When this happens i can sometimes hear a creaking noise coming...

Vivaro clutch pedal
↧
Search

Minibus Speakers

May 1, 2016, 2:04 pm
$
0
0
Hi all.

New to all this and don't want to purchase the wrong sizes and seriously doubt myself on the simple task of measuring.

Anyone know the right size speakers in the roof in the rear of a Vauxhall Vivaro Minibus and also the size of the speakers that is located in the dash.

I think I'm right in thinking that the door speakers are 17cm jobbies,please correct me if I'm wrong.

Thank you.
↧
↧

Spot lights with side lights in

May 1, 2016, 2:09 pm
$
0
0
hey guys

Can someone tell me how to wire up these spot lights basically the have three wires one earth one live for full beam one live for side lights

I've ran a earth from the body took the live from full beam and side lights but when I test the wires the live to the side lights is earthing when not turned on and then 12v when switched on, what am I missing here coz abviously if I plugged them in at that I'd send live straight to ground

Help I know these van have a funny way of...

Spot lights with side lights in
↧

Trafic (Vivaro) steeringbwheel swap?

May 1, 2016, 4:55 pm
$
0
0
Chaps, looking to try something that has never been done before.

I would like to swap over the standard trafic steering wheel with one off of a megane 2008>

The centre hole looks the same size but my concern would be trying to get the megane air bag to work with the existing trafic airbag wiring. Would this be too hard to do and does anyone know how they are wired?

Crazy idea I know

Cheers
Paul
↧

Rang rover sport alloys

May 2, 2016, 11:32 am
$
0
0
Prob been asked a few times but do the Range Rover sport alloys fit with the same kit as the BMW in ring and wobble bolts?

Or is there an alternative kit for this conversion.

Thanks
↧
↧

Vivaro vibration/wobble

May 2, 2016, 3:34 pm
$
0
0
Hi all, I'm looking for some advice. I have a 2005 vivaro 2.5, with an annoying vibration which starts at about 1700 rpm till bout 2000, the more load the worse it gets. makes the van feel as if it is labouring. Lately it seems to have developed into a wobble, not sure if they are the same problem. I have checked all the usual stuff, wheel imbalance, suspension wear, and drive shafts, and found nothing obvious. I would appreciate a bit of advice from someone who has had similar problems,...

Vivaro vibration/wobble
↧

Vivaro engine vibration at around 1800rpm

May 2, 2016, 4:35 pm
$
0
0
My 2005 1.9CDTi has a really bad resonance vibration around 1800rpm. Anyone have any ideas on how to cure it? My first thought would be new engine mounts....?
↧

http://turbo-specialist.co.uk

May 3, 2016, 1:46 am
$
0
0
anyone used these before? been quoted £400 inc vat (plus service parts) to fit a recon BorgWarner turbo? or been quoted £285 + VAT for a recon garrett (no fitting)
↧
Search

Diagnostic Tool ?

May 3, 2016, 3:01 am
$
0
0
Hi Guys

I've got an oldie (2002 1.9 Primastar), with some of the usual issues, and the glowplug/elec issue warning light on at the moment.
I thought I could plug my OBD 2 in to get some fault readings, however seems not to be the case - nothing !

Can anyone help point me in the direction of a reasonably priced reader that's works with our system - which is what ?

Thanks guys
Any help appreciated.
↧
↧

fuel

May 3, 2016, 5:31 am
$
0
0
has anyone heard of or used 2strke oil in their deisel as a extra lubricator for fuel pump
↧

Zx1

May 3, 2016, 5:37 am
$
0
0
Hi is there anybody on here ever used extralube zx1 additive
↧

towing eye

May 3, 2016, 9:23 am
$
0
0
seems the towing eye on my vivaro has has the threads stripped out can it be replaced or can i buy a big eye bolt to fit right through and bolt up at the back?
↧

viv mechanic's

May 3, 2016, 9:31 am
$
0
0
HI all
It's me again maybe looking for a viv mechanic around wolves area that will help me sort out my van before the red plastic can and a match take over lol.
Still can't get it to rev about 2500 drives great if you take time to build up speed but got no excel,
change maf and boost sensor checked pipework. Anyone use a mechanic that may help with out changing sensors one after other and costing fortune.
any help thanks
stu
↧
↧

2006- boost fault.

May 3, 2016, 12:33 pm
$
0
0
My first call for help, and hopefully my last.
2006 1.9T can drive all day in town no issues, and on the motorways etc at 70 without an issue.

However, if i am cruising and put my foot down around 2750 the glowplug light comes on, when checked on a diagnostic tool it says boost solenoid issue, so i changed it, still happens, before i go mad and spend a fortune any ideas.

It will still cruise at 70 or even more but when we get to a hill just dies and i struggle to get more than 45/50 (its...

2006- boost fault.
↧

2006 1.9di vivaro engine fault codes

May 3, 2016, 2:05 pm
$
0
0
Hi,
More problems with my Vivaro.
Past few weeks the orange warning light on the dash has been on when I take my foot off the accelerator, when I accelerate the light goes off and sometimes when I change gear the engine revs shoot up until I'm in the next gear. Now the orange light is on and the engine seems to be running on 3 cylinders.
I connected my Ofcom and fault codes are:

P1122 Present
(6) Accelerator Pedal Position Sensor 1-2...

2006 1.9di vivaro engine fault codes
↧
Search

Random engine cut out

May 3, 2016, 3:53 pm
$
0
0
Hi all, quick question, over the past few days by 2.0cdti has had the engine cut out twice, it happens whilst driving and if I stop, turn key off and the restart the engine will start first time and run normally again?
Any ideas?
↧

Just a quickie on gear cables lads

May 4, 2016, 8:45 am
$
0
0
hey guys

As most know my van gets treated like a princess, well tonight after 178k mikes on the clock the gear cable decided to pop off

No problem popped out and stuck zip tie on question is these Matlock clips do I put one on both cables or just buy one for the one that's popped off

Also as I like to do things right should I buy new cables ?? Or live with the Matlock fix

Cheers guys
↧
↧

Linkage cable

May 4, 2016, 11:45 am
$
0
0
I posted in a separate thread, but need help asap, so thought I'd start my own thread on this.

Sorry for sounding like a total newbie, but I'd much rather sort this myself for only a few quid than have to deal with garages. Unfortunately I don't have any buddies that have the knowledge either.

How do I get to the linkage cable to fix it down with a cable tie? I've had a look, but have no idea what I'm looking at! Pictures or diagrams would be fantastic. I'm in Norwich if anyone is nearby...

Linkage cable
↧

Vivaro 2004 1.9tdi - Power loss

May 4, 2016, 11:53 am
$
0
0
Seems to be lacking power intermittently, like the turbo isn't cutting in. It will go like the clappers for a good ten minutes drive, then seems to `lose interest`.
EGR valve and sensor have been changed, this has definitely helped but it still loses power on a journey.
Also MAF sensor changed (clutch switch seems ok). Garage couldn't find any fault codes.
Ive had this back to the garage 4 times and its really not getting any better - any ideas would be appreciated!
↧

Vivaro replacement panel behind rear bumper

May 4, 2016, 2:47 pm
$
0
0
Hi.
I am tempted to buy a vivaro with light rear damage.
It is hit square in center of rear doors needs bumper and I know the panel behind the bumper is pushed in too.
I have Google searched and can't find any body listing any rear panels.
I've got access to all the correct welding gear and tools so quite happy to de spot weld and fit new panel if available.
Anybody on hear replaced this panel.
Thanks for your time Steve.
↧
Viewing all 5961 articles
Browse latest View live
Search
<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>